How To Tie the Bimini Twist Knot?

How to tie the bimini twist knot

The Bimini Twist is the strongest knot for offshore and in-water trolling with a braided mainline.

It was designed to meet the needs of anglers who chase tuna, marlin, and wahoos. The leader is then attached by most anglers using a Yucatan or Bristol knot. This creates a strong connection.

The Bimini Twist, which often reaches the magic 100% knot strength is one of the most popular and widely used knots in salt.

Bimini Twist Knot: Good Knot to Join Braid to Fluoro Leader

StrengthExcellent
SpeedPoor
It’s easy: Poor
Utility: Very good

How to tie the bimini twist knot

  1. Wrap your mainline about your hand, and then twist the tag around it.20-30 times. You should aim for at least 6 inches of the loop. Some anglers prefer 6 feet or more.
  2. Keep the twists in place. Your feet turn the loop around and pull it up to the outside of your knees. This will allow to properly tension of the knot.
  3. Spread the mainlines and tag to make the twists more pronounced
  4. Gently spread your knees to increase tension and feed the tag end over the twists. The twists should be wrapped in a second layer.
  5. Secure these wraps once your tag ends reach the bottom by attaching them with a simple half-hitch to one end of the loop.
  6. Attach a second half-hitch to the opposite leg.
  7. To make the loop narrower, remove one leg.
  8. Attach the third half-hitch to both legs.
  9. Tie modified half-hitchPass the tag end through the hitch and wrap it around both legs three times.
  10. Trimm the tag at the end.

The Bimini Twist Knot, Fluorocarbon or Braid

The nylon monofilament is very flexible and bites into itself well. This creates enough friction to keep a knot in place. The good news is that the Bimini Twist can be used in heavy mono mainlines.

However, braiding and fluorocarbon can be difficult for anglers.

The Dyneema and Spectra fibers, which are woven together to make braided lines, are slick and slide against each other. This can drastically decrease knot strength because your line prefers to pull through to hold.

Fluorocarbon is a hard material that presents a similar problem. It is unable to easily deform against itself and prefers to slide overbites.

The good news about the Bimini Twist braid knot is its ability to create friction and distribute loads. Tie it well and you won’t find a stronger knot.

However, there have been misinformations about the Bimini Twist which continue to be repeated in sportfishing.

2007Sportfishing MagazineReports incorrectly Bimini Twist worked better when there were fewer twists. These reports continue to be spread via word-of-mouth on fishing message boards.

It is false!

Subsequent testing has shown that errors were made in the original article. Sportfishing Magazine reversed their claims and now recommends 20-30 twists.

Repeated tests have proven that more is always better.

Why Rely on the Bimini Twist Knot

The Bimini Twist, also known as a loop or “doubling” loop knot, creates a long loop that is secured by repeated twists.

One advantage is this:

  • StrengthThe Bimini Twist distributes loads over a large area and has a doubled mainline. It is almost unbelievable how strong it is. It has been tested to 100% of its test strength when tied in an undamaged braid.

What happens when Bimini Twist Knots fail?

Although the Bimini Twist is famous for its ability to hold in a braid, it can also fail if these two common errors are made:

  • This knot can be tied in worn or damaged lines it is possible to see the damage but it could be as simple as UV degrading. This knot or any other knot that is tied in a frayed, worn, or compromised line will not hold.
  • Improper technique –The Bimini Twist can be very difficult to master. You must use neat, tight half-hitches and downward wraps to avoid the knot from slipping.

The Bimini Twist Knot is a great option.

The strength of the Bimini Twist comes with a cost.

  • Slow –Even with experience and practice, this knot can take a lot of time to tie. Worse, the Bimini Twist creates an intricate loop that needs a second knot to secure it.
  • Hard –Although it is not the easiest knot, the Bimini Twist can be tied with ease. To get the best strength out of it, you must make sure that you tie this difficult knot correctly.
Lewis
Lewis Mark is a vastly experienced fly fisher. His encyclopedic knowledge of fly tying has led to start blog on fishing. He also review Fishing equipment based on his knowledge and experience.